3116-2745-0001
Servo Extension via CAT6 (Sending Board)
£10.63
£8.86
This board takes a servo signal from an RC receiver or other source and sends it to a CAT6 cable via an RJ45 port.
.jpg)
This Sending Board is the counterpart to the Receiving Board (3116-4527-0001).
COMPATIBILITY
Ethernet Cables: While CAT6 is the recommeded cable, the RJ45 connector this Boosted Servo Extension uses is also compatible with CAT5, CAT5e, CAT6a, and CAT8 cables.
RC Receivers: This Boosted Servo Extension is compatible with any receiver which uses a PWM signal. This is just about any receiver in the hobby or small-medium robotics industries.
Actobotics Electronics: While this Boosted Servo Extension uses CAT6, it utilizes a newer protocol than the Actobotics CAT6 boards (605102, 605103, 902MSD) making them incompatible with each other.
Related Products
Check items to add to the cart or
.jpg)
| Weight | Board = 10.6g Board with case and hardware - 19.7g |
| Recommended Voltage Range | 6V -15V |
| Max Voltage Range | 3.3v - 18V |
| Signal Channels | 4 |
| Max Current (When powered at Receiving Board) | 16A Total (4A per Channel) |
| Max current over CAT6 (When powered at Sending Board) | 4A Total |
| Servo compatibility | Analog & Digital |
| Maximum Recommended Ethernet Cable Length | 100ft (30M) |
| Power Compatibility | TJC8, XT30, 3mm Solder Holes |
