This is a demo store. No orders will be fulfilled.

3430

FEETECH Continuous Rotation Servo FS5106R

£14.99 £12.49

The FS5106R is a standard-sized servo that has been built by FEETECH specifically for continuous rotation, making it an easy way to get your robot moving.

  • Key specs at 6 V: 95 RPM (no-load), 83 oz-in (6 kg-cm), 40 g
  • Horn gear spline - 25 Teeth

Or

This servo can work with both 5 V and 3.3 V servo signals. It features two ball bearings on the output shaft for reduced friction, and it offers easy access to the rest-point adjustment potentiometer. 

At 6 V, it has a maximum rotation speed of 95 RPM (no-load) and can produce up to 83 oz-in (6 kg-cm) of torque.

It features two ball bearings on the output shaft for reduced friction, and it offers easy access to the rest-point adjustment potentiometer.

The servo can be controlled using a direct connection to a single microcontroller I/O line without any additional electronics, which makes it a great actuator for beginner robotics projects.

The FS5106R continuous rotation servo converts standard RC servo position pulses into continuous rotation speed.

The default rest point is 1.5 ms, but this can be adjusted by using a small screwdriver to turn the middle-point positioner.

Pulse widths above the rest point result in counterclockwise rotation, with speed increasing as the pulse width increases; pulse widths below the rest point result in clockwise rotation, with speed increasing as the pulse width decreases.

General specifications:

Digital No
Speed @ 6V  95 rpm
Stall torque @ 6V 83 oz-in
Speed @ 4.8V 78 rpm
Stall torque @ 4.8V  70 oz-in
Lead length 12 in
Hardware included?  Yes
  • Datasheet for the FEETECH Continuous Rotation Servo FS5106R (133k pdf)

    Note: the free-run speed specifications appear to be incorrect in this datasheet. In our tests, the maximum no-load speeds were 95 RPM at 6 V and 78 RPM at 4.8 V, and these are the numbers we have published on our product page.