This is a demo store. No orders will be fulfilled.

ENC4107_0

ENC4107_0 Draw Wire Encoder (1.5m)

£229.87 £191.56

Like a digital tape measure, this 1500mm draw wire encoder measures the length of wire pulled out of it.

Or

In complex mechanical systems, it is often very difficult to accurately measure the movement of a single part, particularly if it has several degrees of freedom. The draw wire encoder is a versatile solution to this very problem; it can be attached to a part using an M5 screw or fastened to the end with a zip tie, and the encoder itself has a pair of M5 screw threads on the back for easy installation.

FUNCTIONAL

When the wire is pulled out, the sensor produces a quadrature signal to describe the length of wire exposed. The reel is spring loaded, so it will retract when there is no tension in the wire. Multiple draw wire sensors could be used to track the position in more than one dimension.

Connection

This quadrature encoder can be read by an encoder interface by fitting the end of the cable with the appropriate connector. See the Connection & Compatibility tab for details.

Encoder Properties

Manufacturer Part Number

RLC50D-1500-D1F-1M

Output Circuit Type

Push-Pull

Length Resolution

100 μm/cyc

Wire Pull Length

1.5 m

Electrical Properties

Supply Voltage Max

5 V DC

Current Consumption Max

60 mA

Physical Properties

Wire Load Maximum

255 g

Wire Pull Speed Max

1 m/s

Weight

485 g

Operating Temperature Min

-30 °C

Operating Temperature Max

90 °C

Screw Thread Size

M5

IP Rating

IP54