This is a demo store. No orders will be fulfilled.

3531

3531_0 Optical Rotary Encoder HKT22, 3531

£34.68

This low-cost encoder is designed to fit on the rear shaft of our stepper motors. Measure the rotation of your motor even when it stalls or missteps.

Includes:
 

  • 0.9 mm Hex Key for set-screws
  • Plastic encoder cap and mount
  • Encoder disk
  • Encoder PCB
  • Two screws
  • 3035 - Cable for HKT22 Encoder
Or

This compact, economical optical quadrature encoder can be attached to the 4mm rear shaft of a motor. It has 300 counts (full quadrature cycles) per rotation and can be installed by fitting it over the shaft, mounting it to the back of the motor, and tightening the set-screw. This encoder does not support the use of an index channel.

 

The mounting holes on the HKT22 encoder line up with the holes on the back of any rear-shaft stepper motor from Phidgets, Inc. It connects to any of the following interface boards via the included cable:

Encoder Properties

Output Circuit Type Push-Pull (Single-Ended)
Encoder Resolution 300 CPR

 

Electrical Properties

Supply Voltage Min 5 V DC
Supply Voltage Max 5 V DC
Output Frequency Max 30 kHz

 

Physical Properties

Shaft Diameter 4 mm
Operating Humidity Min 30 %RH
Operating Humidity Max (Non-condensing) 85 %RH
Operating Temperature Min -10 °C
Operating Temperature Max 85 °C
IP Rating IP40
Weight 4 g